Search SchoolNGR

Saturday, 21 November 2026
Register . Login

Physics Past Questions and Answers

Topic: Screw guage

Jamb Physics Questions - Screw guage

Question 6:
In the calibration of an ammeter using faraday's laws of electrolysis, the ammeter reading is kept constant at 1.2A. If 0.990g of copper is deposited in 40 minutes , the correction to be applied to the ammeter is
  • A 0.03A
  • B 0.04A
  • C 0.05A
  • D 0.06A
View Answer & Explanation
Question 7:
A generator manufacturing company was contracted to produce an a.c dynamo but inadvertently produced a d.c dynamo. To correct this error, the
  • A Armature coil should be made of silver
  • B Commutator should be replaced with slip ring
  • C Commutator should be replaced with split rings
  • D Armature coil should be made of aluminium
View Answer & Explanation
Question 8:
I. Diameter of a small ball bearing.
II. Thickness of a pieces of paper.
III. Diameter of a measuring cylinder.
IV. Length of a piece of wire.
Which of the above can be measured using a micrometer screw gauge?
  • A I, II and IV only .
  • B I and II only
  • C II and III only
  • D III and IV only
View Answer & Explanation
Question 9:
The inner diameter of a small test tube can be measured accurately using a
  • A Micrometres screw gauge
  • B Pair of dividers
  • C Metre rule
  • D Pair of vernier calliper
View Answer & Explanation
Question 10:
Calculate the velocity ratio of a screw jack of pitch 0.2cm if the length of the tommy bar is 23cm
  • A 230\(\pi\)
  • B 23\(\pi\)
  • C 70\(\pi\)
  • D 140\(\pi\)
View Answer & Explanation